Marke / Kategorie: Bondtech
Die Halterung wird zwischen dem Motor und dem hinteren Gehäuse des Extruders geklemmt. Sie kann in 90-Grad-Schritten gedreht werden, um den Extruder nach deinen Bedürfnissen zu montieren. Die Montagebohrungen im unteren Flansch haben einen Durchmesser von 4,2 mm. vertikal 18,0 mm, horizontal 50,0 mm.
- BondTech BMG ALU-Mount ist ein Artikel vom Anbieter buw. Hersteller Bondtech.
Like upgrading the engine in your car, suddenly an unsuspecting machine can compete with the top of the line. The 50W Heater Cartridge ...
| Dimensions |
BondTech DDG Ultimaker 2+ Extruder KitThe original stepper motor of the printer will be reused and the extruder will be mounted at the same position and in the same mounting holes as the factory extruder making the installation easy and fast in about 10 minutes. E-steps needs to be ... 
BondTech DDX v3 Adapter Set For Creality Ender - CR-10The DDX v3 is much easier to installWith the integrated fan shroud and mount included in the DDX v3 adapter sets, the DDX v3 is even easier to install. Snap the fan to the shroud without using screws. Adjust the height of the shroud with one front ... |
|---|