BondTech Wanhao D6 Extruder Kit unter Bondtech
BondTech Wanhao D6 Extruder Kit

BondTech Wanhao D6 Extruder Kit

Marke / Kategorie: Bondtech

This extruder upgrade kit for the Wanhao Duplicator 6/Monoprice duplicator 6 will replace the original feeder.

It allows for a more reliable printing with all sorts of filaments, both stiff and flexibles and the DualDrive system ensures that the extruder never looses grip of the filament so grinding, slipping is a thing of the past.

The original motor are used and the PTFE feedtube is held securly in place with an industrial 4 mm Push-fit connector for reliability.

Installs in about half an hour with standard tools available.

E-steps needs to be updated to 415 and to avoid that the printhead collides with the rear frame the max movement needs to be reduced to 190 mm in the Y-direction. A new firmware is available for download with the necessary changes implemented.

On some printers the printhead has trouble reaching the Y-homing endstop before the front of the extruder collides with the frame, in order to solve this an o-ring is included that slides over the x-shaft that makes the endstop to be activated earlier, instructions of how to do this is available under the Installation guide tab.

Full installation vido guide available at the tab installation guide..

- BondTech Wanhao D6 Extruder Kit ist ein Artikel vom Anbieter buw. Hersteller Bondtech.

Weiteres aus Bondtech

BondTech Motor Cable JST-XH6 -  JST-XH4

BondTech Motor Cable JST-XH6 - JST-XH4

This cable is by default wired for our 40 mm Geared Nema17 motor, please make sure that it follows the schematics for your application.

Controller side      Motor side
PIN 1  —————– PIN 1
PIN 2 —————– PIN 4
PIN 3 —————– PIN 3
PIN 4 —————– ...

BondTech DDX v3 Adapter Set For Creality CR-10S Pro - Max

BondTech DDX v3 Adapter Set For Creality CR-10S Pro - Max

The DDX v3 is much easier to install

With the integrated fan shroud and mount included in the DDX v3 adapter sets, the DDX v3 is even easier to install. Snap the fan to the shroud without using screws. Adjust the ...

BondTech Upgrade Kit for Creality CR-10 with mount

BondTech Upgrade Kit for Creality CR-10 with mount

Bondtech Aufrüstsatz für Creality CR-10

Dieses Extruder-Upgrade-Kit für den Creality CR10, CR10S, Ender, Tevo Tornado und andere Drucker, die die gleiche Art von Montageplatte verwenden, ersetzt den Original-Feeder.

Es ...

BondTech Drivegear Kit 1-75 mm - 5 mm

BondTech Drivegear Kit 1-75 mm - 5 mm

Bondtech-Antriebssatz

Diese Antriebszahnradsätze werden als Satz geliefert, bestehend aus einem primären Antriebszahnrad, einem sekundären Antriebszahnrad, Lagern und einer Welle.

  • Zahnradsatz für Filamentgröße 1,75 mm, ...