Marke / Kategorie: Bondtech
The original stepper motor of the printer will be reused and the extruder will be mounted at the same position and in the same mounting holes as the factory extruder making the installation easy and fast in about 10 minutes.
E-steps needs to be updated to 311
Firmware with adjusted E-step is available for Ultimaker2+, Ultimaker2+ Extended or you can send a M-code to the printer directly to set the e-steps (more info here) under the section E-steps.
This extruder is developed together with C.Matthes in Germany
- BondTech DDG Ultimaker 2+ Extruder Kit ist ein Artikel vom Anbieter buw. Hersteller Bondtech.
17 teeth gear in brass with M3x3 setscrew used in our BMG, Single and Dualdirect extruders.
Please make sure that the setscrew does not collide with the secondary plastic gear when assembled.
Max Input current: 0.8A
Step angle: 1.8 deg.
Torque: 12 Ncm
Outputshaft diameter: 5.0 mm with flat.
Hole for mounting: 31 mm, 4xM3
Motor lenght: 22mm
Max Input current: 0.7A per phase
Step angle: 1.8 deg.
Torque: 18 Ncm
Outputshaft diameter: 5.0 mm
Hole for mounting: 31 mm, 4xM3
Motor lenght: 25mm
