Marke / Kategorie: Bondtech
This extruder upgrade kit for the Creality CR10S, Ender, Tevo Tornado and other printers that uses the same type of mounting plate will replace the original feeder.
It allows for a more reliable printing with all sorts of filaments, both stiff and flexibles and the DualDrive system ensures that the extruder never looses grip of the filament so grinding, slipping is a thing of the past.
The bowden tube is securly held in place by the 4mm industry standard integrated push-fit connector.
This kit comes in 3 versions. Without mount, With mount and With mount for a filament sensor.
E-steps needs to be updated to 415 and the rotation direction of the motor needs to be reversed, please see the installation guide of how to do it that you will find under the tab Installation guide
This kit contains no motor, the original motor is used.
These drivegear kits come as a set consisting of a primary drive gear, a secondary drive gear, bearings and a shaft.
Max Input current: 0.8A
Step angle: 1.8 deg.
Torque: 12 Ncm
Outputshaft diameter: 5.0 mm with flat.
Hole for mounting: 31 mm, 4xM3
Motor lenght: 22mm
With the integrated fan shroud and mount included in the DDX v3 adapter sets, the DDX v3 is even easier to install. Snap the fan to the shroud without using screws. Adjust the ...
Die Halterung wird zwischen dem Motor und dem hinteren Gehäuse des Extruders geklemmt. Sie kann in 90-Grad-Schritten gedreht werden, um den Extruder nach deinen Bedürfnissen zu montieren. Die Montagebohrungen im ...