Marke / Kategorie: Bondtech
700 mm, Dupont cable 4-pin connector with locking function to JST-XH6 6-pin connector.
This cable is by default wired for our 40 mm Geared Nema17 motor, please make sure that it follows the schematics for your application.
Controller side Motor side
PIN 1 —————– PIN 1
PIN 2 —————– PIN 4
PIN 3 —————– PIN 3
PIN 4 —————– PIN 6
If it is going to be used with our 25 mm Pancake motor then swap position of the two center wires in order to have a correct connection like below.
Controller side Motor side
PIN 1 —————– PIN 1
PIN 2 —————– PIN 3
PIN 3 —————– PIN 4
PIN 4 —————– PIN 6
| Dimensions | 70 cm |
|---|
Max Input current: 0.8A
Step angle: 1.8 deg.
Torque: 12 Ncm
Outputshaft diameter: 5.0 mm with flat.
Hole for mounting: 31 mm, 4xM3
Motor lenght: 22mm
Kaufe dir diesen BondTech DualDirect Extruder-Upgrade für deinen Raise3D.
Dieses neue kompakte, leichte Extruder-Upgrade für deinen Raise3D-Drucker wird deine Zuführprobleme lösen, die ...
This extruder upgrade kit for the Wanhao Duplicator 6/Monoprice duplicator 6 will replace the original feeder.
It allows for a more reliable printing with all sorts of filaments, both stiff and flexibles and the DualDrive system ensures that the ...
