BondTech Drivegear Kit 1-75 mm - 8 mm unter Bondtech
BondTech Drivegear Kit 1-75 mm - 8 mm

BondTech Drivegear Kit 1-75 mm - 8 mm

Marke / Kategorie: Bondtech

These drivegear kits come as a set consisting of a primary drive gear, a secondary drive gear, bearings and a shaft.

  • Gear set for filament size 1.75 mm, primary gear with inner diameter 8 mm, secondary gear with integrated needle bearings, M4x3 setscrew and one 4 x 22 mm shaft.

A Lithium based grease is recommended to use on the gear section and inside the needle bearings for low friction and to avoid wear. A small dab of grease is enough.

- BondTech Drivegear Kit 1-75 mm - 8 mm ist ein Artikel vom Anbieter buw. Hersteller Bondtech.

Weiteres aus Bondtech

BondTech Upgrade Kit for TEVO Tornado

BondTech Upgrade Kit for TEVO Tornado

This extruder upgrade kit for the Tevo Tornado, Creality CR10, Ender, and other printers that uses the same type of mounting plate will replace the original feeder.

It allows for a more reliable printing with all sorts of ...

BondTech DDX v3 Adapter Set For Creality Ender - CR-10

BondTech DDX v3 Adapter Set For Creality Ender - CR-10

The DDX v3 is much easier to install

With the integrated fan shroud and mount included in the DDX v3 adapter sets, the DDX v3 is even easier to install. Snap the fan to the shroud without using screws. Adjust the height of the shroud with one front ...

BondTech Motor Cable JST-XH6 - PC2510

BondTech Motor Cable JST-XH6 - PC2510

PC2510 4-poliger Stecker auf JST-XH6 6-poliger Stecker

Dieses Kabel ist standardmäßig für unseren 40 mm Getriebemotor Nema17 verdrahtet, bitte stellen Sie sicher, dass es den Schaltplänen für Ihre Anwendung entspricht.

...

BondTech Wanhao D6 Extruder Kit

BondTech Wanhao D6 Extruder Kit

This extruder upgrade kit for the Wanhao Duplicator 6/Monoprice duplicator 6 will replace the original feeder.

It allows for a more reliable printing with all sorts of filaments, both stiff and flexibles and the DualDrive system ensures that the ...