Bondtech Mosquito 24V 50W heater unter Bondtech
Bondtech Mosquito 24V 50W heater

Bondtech Mosquito 24V 50W heater

Marke / Kategorie: Bondtech

  • Compatibility : for units with 24v PSUs
  • Power : 50W

For Engineering-grade Plastics

Like upgrading the engine in your car, suddenly an unsuspecting machine can compete with the top of the line. The 50W Heater Cartridge takes your 3D printer and opens a whole new world of engineering-grade plastics that other off-the-shelf desktop printers can’t come close to. Materials like Nylon, Ultem, PEEK, and other plastics you always wanted to use for molds, medical devices, end use parts, or automotive components, they are now well within your reach.

Easy To Setup

Take the raw power of your 3D printer to the next level with a simple plug and play modification. Designed for effortless use, implementation, and reliability. We use 1.2 meter cables that make it easy to reach the control board of even the largest printer, and with long bare leads, it can be installed in many more 3D printer models.

Do you want to see your unsuspecting printer churn out engineering-grade plastics without breaking a sweat?

By Slice Engineering

*Some 3D desktop printers are capped at a certain temperature for safety reasons, and the manufacturer won’t lift it. Check with your printer model to see if it allows you to print at your desired temperature.

- Bondtech Mosquito 24V 50W heater ist ein Artikel vom Anbieter buw. Hersteller Bondtech.

Weiteres aus Bondtech

BondTech BMG ALU-Mount

BondTech BMG ALU-Mount

Halterung für BMG-Extruder

Die Halterung wird zwischen dem Motor und dem hinteren Gehäuse des Extruders geklemmt. Sie kann in 90-Grad-Schritten gedreht werden, um den Extruder nach deinen Bedürfnissen zu montieren. Die Montagebohrungen im ...

BondTech Upgrade Kit for TEVO Tornado

BondTech Upgrade Kit for TEVO Tornado

This extruder upgrade kit for the Tevo Tornado, Creality CR10, Ender, and other printers that uses the same type of mounting plate will replace the original feeder.

It allows for a more reliable printing with all sorts of ...

BondTech Motor Cable JST-XH6 -  JST-XH4

BondTech Motor Cable JST-XH6 - JST-XH4

This cable is by default wired for our 40 mm Geared Nema17 motor, please make sure that it follows the schematics for your application.

Controller side      Motor side
PIN 1  —————– PIN 1
PIN 2 —————– PIN 4
PIN 3 —————– PIN 3
PIN 4 —————– ...