Marke / Kategorie: Bondtech
These drivegear kits come as a set consisting of a primary drive gear, a secondary drive gear, bearings and a shaft.
A Lithium based grease is recommended to use on the gear section and inside the needle bearings for low friction and to avoid wear. A small dab of grease is enough.
- BondTech Drivegear Kit 2-85-3-0 mm - 8 mm ist ein Artikel vom Anbieter buw. Hersteller Bondtech.
This extruder upgrade kit for the Ultimaker printers replaces the original feeder, it comes with it´s own Nema17 high precision geared steppermotor.
It allows for a more reliable printing with all sorts of filaments, both stiff and flexibles and the ...
Weight: 406g
Max Input current: 1.2A
Step angle: 1.8 deg.
Gear ratio: 5.18:1
Outputshaft diameter: 8.0 mm
Hole circle for mounting: 28 mm, 4xM3
Motor lenght: 40mm
700 mm, Dupont cable 4-pin connector with locking function to JST-XH6 6-pin connector.
This cable is by default wired for our 40 mm Geared Nema17 motor, please make sure that it follows the ...
These drivegear kits come as a set consisting of a primary drive gear, a secondary drive gear, bearings and a shaft.