Marke / Kategorie: Bondtech
Weight: 406g
Max Input current: 1.2A
Step angle: 1.8 deg.
Gear ratio: 5.18:1
Outputshaft diameter: 8.0 mm
Hole circle for mounting: 28 mm, 4xM3
Motor lenght: 40mm
Max Input current: 0.8A
Step angle: 1.8 deg.
Torque: 12 Ncm
Outputshaft diameter: 5.0 mm with flat.
Hole for mounting: 31 mm, 4xM3
Motor lenght: 22mm
This cable is by default wired for our 40 mm Geared Nema17 motor, please make sure that it follows the schematics for your application.
Controller side Motor side
PIN 1 —————– PIN 1
PIN 2 —————– PIN 4
PIN 3 —————– PIN 3
PIN 4 —————– ...
The original stepper motor of the printer will be reused and the extruder will be mounted at the same position and in the same mounting holes as the factory extruder making the installation easy and fast in about 10 minutes.
E-steps needs to be ...
With the integrated fan shroud and mount included in the DDX v3 adapter sets, the DDX v3 is even easier to install. Snap the fan to the shroud without using screws. Adjust the height of the shroud with one front ...