Marke / Kategorie: Bondtech
This extruder upgrade kit for the Flashforge creator pro 2016 dual nozzle printer will replace the original feeders and coldblock.
It allows for a more reliable printing with all sorts of filaments, both stiff and flexibles and the DualDrive system ensures that the extruder never looses grip of the filament so grinding, slipping is a thing of the past.
The original motors are used and the PTFE feedtube is held securely in place with an industrial 6 mm Push-fit connector for reliability.
Installs in about one hour with standard tools available. Full installation guide available at the tab installation guide.
This block has an 7.80 mm hole through the coldblock for the factory default heatbreak.
Please verify that your heatbreak fits before placing your order.
With the integrated fan shroud and mount included in the DDX v3 adapter sets, the DDX v3 is even easier to install. Snap the fan to the shroud without using screws. Adjust the ...
These drivegear kits come as a set consisting of a primary drive gear, a secondary drive gear, bearings and a shaft.
700 mm, Dupont cable 4-pin connector with locking function to JST-XH6 6-pin connector.
This cable is by default wired for our 40 mm Geared Nema17 motor, please make sure that it follows the ...
The LGX™ For Flexibles Set includes a reversible heat sink that can be installed on the left or right hand side of the cold block. The heat sink also includes the hole pattern for attaching 40×40 ...