Marke / Kategorie: Bondtech
Max Input current: 0.7A per phase
Step angle: 1.8 deg.
Torque: 18 Ncm
Outputshaft diameter: 5.0 mm
Hole for mounting: 31 mm, 4xM3
Motor lenght: 25mm
The LGX™ For Flexibles Set includes a reversible heat sink that can be installed on the left or right hand side of the cold block. The heat sink also includes the hole pattern for attaching 40×40 ...
17 teeth gear in brass with M3x3 setscrew used in our BMG, Single and Dualdirect extruders.
Please make sure that the setscrew does not collide with the secondary plastic gear when assembled.
Kaufe dir diesen BondTech DualDirect Extruder-Upgrade für deinen Raise3D.
Dieses neue kompakte, leichte Extruder-Upgrade für deinen Raise3D-Drucker wird deine Zuführprobleme lösen, die ...
700 mm, Dupont cable 4-pin connector with locking function to JST-XH6 6-pin connector.
This cable is by default wired for our 40 mm Geared Nema17 motor, please make sure that it follows the ...