BondTech QR EXTRUDER

Weiteres aus Bondtech

BondTech Motor Cable JST-XH6 - JST-XH4

This cable is by default wired for our 40 mm Geared Nema17 motor, please make sure that it follows the schematics for your application.

Controller side Motor side
PIN 1 —————– PIN 1
PIN 2 —————– PIN 4
PIN 3 —————– PIN 3
PIN 4 —————– ...

BondTech Drivegear Kit 1-75 mm - 8 mm

These drivegear kits come as a set consisting of a primary drive gear, a secondary drive gear, bearings and a shaft.

Gear set for filament size 1.75 mm, primary gear with inner diameter 8 mm, secondary gear with integrated needle bearings, M4x3 ...

BondTech DualDirect Extruder-Upgrade für Raise3D

Kaufe dir diesen BondTech DualDirect Extruder-Upgrade für deinen Raise3D.

Dieses neue kompakte, leichte Extruder-Upgrade für deinen Raise3D-Drucker wird deine Zuführprobleme lösen, die ...

BondTech Upgrade Kit for Creality CR-10 without mount

This extruder upgrade kit for the Creality CR10, CR10S, Ender, Tevo Tornado and other printers that uses the same type of mounting plate will replace the original feeder.

It allows for a more reliable printing with all sorts of filaments, both stiff ...