Marke / Kategorie: Bondtech
This cable is by default wired for our 40 mm Geared Nema17 motor, please make sure that it follows the schematics for your application.
Controller side Motor side
PIN 1 —————– PIN 1
PIN 2 —————– PIN 4
PIN 3 —————– PIN 3
PIN 4 —————– PIN 6
| Dimensions | 70 cm |
|---|
Max Input current: 0.8A
Step angle: 1.8 deg.
Torque: 12 Ncm
Outputshaft diameter: 5.0 mm with flat.
Hole for mounting: 31 mm, 4xM3
Motor lenght: 22mm
These drivegear kits come as a set consisting of a primary drive gear, a secondary drive gear, bearings and a shaft.
17 teeth gear in brass with M3x3 setscrew used in our BMG, Single and Dualdirect extruders.
Please make sure that the setscrew does not collide with the secondary plastic gear when assembled.
